HS89 PRO 30 User Manual
Connection Steps
- Connect HDMI: plug one end into the box's HDMI OUT and the other into the TV's HDMI port (HDMI 2.0 or above recommended for 4K); note the TV input number.
- Connect power: insert the adapter into the DC port and plug into a live wall socket.
- Connect to network (choose one): wired — Ethernet cable from the LAN port to the router LAN port (recommended, more stable); wireless — connect to WiFi via system settings after boot.
- Install remote batteries: insert two AAA batteries following the polarity marks.
Remote Pairing
Hold Back + Home together for more than 4 seconds. The indicator enters a fast-flash state and broadcasts pairing / unpairing for 60 seconds; on success it changes from fast flash to a 2-second slow flash, then goes out. Repeat if pairing fails.
USB Upgrade
- Place the update package in the USB drive root and rename it to
update.zip; - Insert the drive and go to settings → Device Preference → about → localupdate → select the USB drive;
- Watch the progress in notifications and wait for completion.
USB Flashing
On Windows use AmlUSB_Burn_Tool V3.x.x: import the firmware → wait for detection to finish → plug into the USB2.0 (ADB) port, power on while holding the recovery button (hidden deep inside the AV port; use a paper clip) → once detected, click Start; when progress reaches 100% and shows "successful", flashing is complete. The USB2.0 (ADB) port can also supply power to the system.
Package Contents
Main unit x 1, 5V/2A power adapter x 1 (2.1mm barrel), remote x 1, HDMI cable x 1, user manual x 1.
Safety Notes
- Use only the supplied adapter (input 100-240V@50/60Hz, output 5V/2A);
- The device generates heat in operation — allow more than 10cm of clearance and do not cover or enclose it;
- Keep away from water, humid environments and temperatures above 40°C or below 0°C;
- Do not disassemble the unit; servicing must be performed by qualified personnel.