Skip to main content

09A Firmware Flashing

Tool version requirements

Use AndroidTool_Release v2.90 or later (RKDevTool.exe) and DriverAssistant v5.1.1 or later. See Downloads.

1. Install the USB Driver​

If a driver was installed previously, update DriverAssistant to V5.1.1 or later.

  1. Extract the downloaded archive to a path containing only ASCII characters, then double-click DriverInstall.exe.
  2. Click "Driver Install".
  3. Once installation succeeds, click "OK" to exit and close the driver installer.

2. Firmware Flashing on Windows​

  1. Download and extract the flashing tool, open the folder and double-click RKDevTool.exe.
  2. Connect the PC to the board's USB 2.0 OTG port (lower port of the stacked USB) with a USB A-to-A cable.
  3. Hold the Recovery button, then connect the Type-C 5V power supply.
  4. The tool detects the device automatically. Release the Recovery button once "Found One LOADER Device" appears.
  5. Click "Upgrade Firmware" → "Firmware" and select the image to flash.
  6. Click "Upgrade"; the progress is shown on the right.
  7. Flashing is complete when the progress reaches 100% and the tool detects an ADB device.
info

If the eMMC is blank or the firmware is corrupted, the tool may report a MASKROM device. Hold the Maskrom button while powering on to enter MaskRom mode — see Interfaces.

3. Writing MAC Addresses​

Tool: RKDevInfoWriteTool_Setup_V1.1.4_210527.7z — see Downloads.

Install the USB driver as described in section 1 first (skip if already installed).

  1. Extract and run RKDevInfoWriteTool_Setup_V1.1.4_210527 to install the tool.
  2. Open RKDevInfoWriteTool → Settings → LAN MAC → do not select "Multiple LAN MAC" → check "Select" → choose Increment / Manual → check "Hexadecimal" → enter the MAC address and quantity → Save.
  3. When entering a MAC manually, use 6 pairs of hexadecimal digits.
  4. Connect the PC to the USB 2.0 OTG port with a USB A-to-A cable, hold Recovery while powering on, release once "Found One LOADER Device" appears, then click "Write".
Difference from 08B

The RUPA-RK3572-A1 (08B) requires "Multiple LAN MAC" with MAC0 and MAC1 selected. Do not enable "Multiple LAN MAC" on the RUPA-RK3528-A2.

4. Flashing in Linux​

Tool Preparation​

ItemPath / Version
Tool documentation<SDK>/tools/linux/ToolsRelease.txt
Windows USB driver assistant<SDK>/tools/windows/DriverAssitant_v5.13.zip
Linux flashing toolLinux_Upgrade_Tool V2.26 or later, at <SDK>/tools/linux/Linux_Upgrade_Tool/Linux_Upgrade_Tool
Firmware packaging script<SDK>/tools/linux/Linux_Pack_Firmware/rockdev/mkupdate.sh (generates update.img)
Tool path in Linux SDKtools/linux/Linux_Upgrade_Tool/
Tool path in Android SDKRKTools/linux/Linux_Upgrade_Tool/

Common Commands​

After packaging update.img with mkupdate.sh from the SDK root:

# List connected devices
sudo upgrade_tool ld

# Flash a complete update.img
sudo upgrade_tool uf update.img

Refer to the SDK's ToolsRelease.txt for the definitive command set.